Guyz... plz post the configuration of guitar effects processor patch made by u. Please add processor name and if possible attach a sample sound clip too.. And if anyone here uses Guitar Rig 3 or amplitube or any other software processors, then post the settings of those too... :beer:
Good Thread!! Ete aamar moto oneker-i upokar hobe . Aami kal try korbo ekta sound clip post korte, aar tarpor patch-er golpo likhte boshbo :shock:.
https://www.soundclick.com/bands/default.cfm?bandID=1006714 Ekhane duto sound clips upload kora aache - duto aalada patch-er: 1. Phased Solo 2. Saptashaw's Lead. Saptashaw's lead patch-ta recording-er shomoy ghete gechhe mone hochhe - kaaron oto-ta pre-delay ki kore aashchhe bujhte parchhi naa. Just an attempt - bajano bhul bhal hoye thakle khoma kore diyo bondhugon. Gears used - Ibanez S470 and Boss GT-10. Recorded through USB using the GT-10.
Saptashaw's Lead: Preamp Section Preamp - 5150 Gain - 90 Bass - 80 Middle - 30 Treble - 40 Presence - 100 Level - 54 Channel Mode - Dual L/R Speaker Type - Original Mic - DYN421 Mic Dis. - On Mic Mic Position - 8 Mic Level - 87 Direct Level - 18 Effects Tone Modify Type - Fat Low - 0 High - 0 Level - 50 Delay Type - Tape Delay Time - 436 ms Feedback - 40 High Cut - Flat Effect Level - 66 Direct Level - 87 Reverb Type - Hall1 Rev. Time - 4.0 s Pre Delay - 21 ms Low cut - 630 Hz High Cut - 4 KHz Density - 10 Effect Level - 50 Direct Level - 100 All Patch Level EQs are set to 0 dB